Dell C9000 series, Reference Manual

Page: 1352 / 2286

lacp long-timeout
Configure a long timeout period (30 seconds) for an LACP session.
C9000 Series
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the
no lacp long-
timeout
command.
Defaults 1 second
Command Modes INTERFACE (conf-if-po-number)
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information This command applies to dynamic port-channel interfaces only. When applied on a
static port-channel, this command has no effect.
Related
Commands show lacp — displays the LACP configuration.
Link Aggregation Control Protocol (LACP) 1352