Dell C9000 series, Reference Manual

Page: 285 / 2286

seq
Assign a sequence number to a deny or permit filter in an IP access list while creating the filter.
C9000 Series
Syntax
seq sequence-number {deny | permit} { source [ mask ] | any | host
ip-address }} [count [bytes]] [dscp value ] [order] [fragments] [log
[interval minutes ] [threshold-in-msgs [count]] [monitor]
To delete a filter, use the
no seq sequence-number
command.
Parameters
sequence-
number Enter a number from 0 to 4294967290.
deny Enter the keyword
deny
to configure a filter to drop packets
meeting this condition.
permit Enter the keyword
permit
to configure a filter to forward
packets meeting this criteria.
source Enter an IP address in dotted decimal format of the network
from which the packet was received.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D. The mask, when specified in A.B.C.D format, may be
either contiguous or non-contiguous.
any Enter the keyword
any
to specify that all routes are subject to
the filter.
host ip-address Enter the keyword
host
then the IP address to specify a host IP
address or hostname.
count (OPTIONAL) Enter the keyword
count
to count packets the filter
processes.
bytes (OPTIONAL) Enter the keyword
bytes
to count bytes the filter
processes.
dscp (OPTIONAL) Enter the keyword
dcsp
to match to the IP DSCP
values. The range is from 0 to 63.
order (OPTIONAL) Enter the keyword
order
to specify the QoS order
for the ACL entry. The range is from 0 to 254 (where 0 is the
highest priority and 254 is the lowest; lower-order numbers
have a higher priority). If you do not use the keyword
order
, the
ACLs have the lowest order by default (255).
fragments Enter the keyword
fragments
to use ACLs to control packet
fragments.
Access Control Lists (ACL) 285