Dell C9000 series, Reference Manual

Page: 1216 / 2286

Version Description
8.1.1.2 Introduced on the E-Series ExaScale E600i.
8.1.1.0 Introduced on the E-Series ExaScale.
7.9.1.0 Introduced VRF on the E-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information The following describes the
show ip cam
command shown in the following example.
Field Description
Index Displays the CAM index number of the entry.
Destination Displays the destination route of the index.
EC Displays the number of equal cost multipaths (ECMP) available
for the default route for non-Jumbo line cards. For Jumbo line
cards, displays 0,1 when ECMP is more than eight.
CG Displays 0.
V Displays a 1 if the entry is valid and a 0 if the entry is for a line
card with Catalog number beginning with LC-EF.
C Displays the CPU bit. 1 indicates that a packet hitting this entry is
forwarded to the CP or RP2, depending on Egress port.
Next-Hop Displays the next hop IP address of the entry.
VId Displays the VLAN ID. If the entry is 0, the entry is not part of a
VLAN.
Mac Addr Displays the next-hop router’s MAC address.
Port Displays the egress interface. Use the second half of the entry to
determine the interface. For example, in the entry 17cl CP, the
CP is the pertinent portion.
• CP = control processor
• RP2 = route processor 2
• Gi = Gigabit Ethernet interface
• So = SONET interface
• Te = 10-Gigabit Ethernet interface
Example
Dell#show ip cam linecard 0 port
‐
set 0
Destination EC C VId Mac
‐
Addr Port
‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐‐
1.1.32.140/32 0 0 200 00:00:00:00:1f:8a PeGigE <PE
‐
ID>/<Slot>/
<Port>
IPv4 Routing 1216