Dell C9000 series, Reference Manual

Page: 2227 / 2286

vlt domain
Enable VLT on a switch, configure a VLT domain, and enter VLT-domain configuration mode.
C9000 Series
Syntax
vlt domain domain-id
Parameters
domain-id Enter the Domain ID number. Configure the same domain ID on
the peer switch. The range of domain IDs is from 1 to 1000.
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.5(0.1) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000.
8.3.19.0 Introduced on the S4820T.
8.3.8.0 Introduced on the S4810.
Usage Information The VLT domain ID must be the same between the two VLT devices. If the domain ID is
not the same, a syslog message is generated and VLT does not launch.
Related
Commands show vlt — uses the
show vlt brief
command to display the delay-restore value.
Virtual Link Trunking (VLT) 2227