Dell C9000 series, Reference Manual

Page: 61 / 2286

1 To enable LLDP globally, verify that you are logged in to CONFIGURATION mode. To enable LLDP on an
interface, verify that you are logged in to INTERFACE mode.
2 Enter the
protocol lldp
command. The prompt changes to include (conf-lldp) or (conf-if- interface -
lldp).
LLDP MANAGEMENT INTERFACE Mode
To enable and configure Link Layer Discovery Protocol (LLDP) on management interfaces, use LLDP
MANAGEMENT INTERFACE mode. For more information, see the
Link Layer Discovery Protocol (LLDP)
chapter in the Dell Networking OS Configuration Guide for the C9000 Series .
To enter LLDP MANAGEMENT INTERFACE mode:
1 Verify that you are logged in to LLDP mode.
2 Enter the
management-interface
command. The prompt changes to include (conf-lldp-mgmtIf).
LINE Mode
To configure the console or virtual terminal parameters, use LINE mode.
To enter LINE mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the
line
command. Include the keywords
console
or
vty
and their line number available on the
switch. The prompt changes to include (config-line-console) or (config-line-vty).
You can exit this mode by using the
exit
command.
MAC ACCESS LIST Mode
To enter MAC ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use
the
mac access-list standard
or
mac access-list extended
command.
To enter MAC ACCESS LIST mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Use the
mac access-list standard
or
mac access-list extended
command. Include a name
for the ACL. The prompt changes to include (conf-std-macl) or (conf-ext-macl).
You can return to CONFIGURATION mode by using the
exit
command.
MONITOR SESSION Mode
To enable and configure a traffic monitoring session using port monitoring, use MONITOR SESSION mode.
For more information, see
Port Monitoring .
To enter MONITOR SESSION mode:
CLI Basics 61