Dell C9000 series, Reference Manual

Page: 1583 / 2286

For MD5 authentication, the key must be 32 hex digits (non-
encrypted) or 64 hex digits (encrypted).
For SHA-1 authentication, the key must be 40 hex digits (non-
encrypted) or 80 hex digits (encrypted).
Defaults Not configured.
Command Modes INTERFACE
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
9.1.(0.0) Introduced on S4810 and Z9000.
8.4.2.0 Introduced on the E-Series.
8.3.19.0 Introduced on the S4820T.
Usage Information Before you enable IPsec authentication on an OSPFv3 interface, first enable IPv6
unicast routing globally, configure an IPv6 address and enable OSPFv3 on the interface,
and assign the interface to an area.
An SPI value must be unique to one IPsec security policy (authentication or encryption)
on the router. Configure the same authentication policy (same SPI and key) on each
OSPFv3 interface in a link.
To remove an IPsec authentication policy from an interface, enter the no ipv6 ospf
authentication
spi number
command. To remove null authentication on an interface
to allow the interface to inherit the authentication policy configured for the OSPFv3
area, enter the
no ipv6 ospf authentication null
command.
Related
Commands
area authentication – configures an IPsec authentication policy for an OSPFv3 area.
show crypto ipsec policy – displays the configuration of IPsec authentication policies.
show crypto ipsec sa ipv6 – displays the security associations set up for OSPFv3
interfaces in authentication policies.
Open Shortest Path First (OSPFv2 and OSPFv3) 1583