Dell C9000 series, Reference Manual

Page: 2017 / 2286

debug protocol-tunnel
Enable debugging to ensure incoming packets are received and rewritten to a new MAC address.
C9000 Series
Syntax
debug protocol-tunnel interface {in | out | both} [vlan vlan-id ]
[count value ]
To disable debugging, use the
no debug protocol-tunnel interface {in |
out | both} [vlan vlan-id ] [count value ]
command.
Parameters
interface Enter one of the following interfaces and slot/port information:
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
in | out | both Enter the keyword
in
,
out
, or
both
to debug incoming
interfaces, outgoing interfaces, or both incoming and outgoing
interfaces.
vlan vlan-id Enter the keyword
vlan
then the VLAN ID. The range is from 1
to 4094.
count value Enter the keyword
count
then the number of debug outputs.
The range is from 1 to 100.
Defaults Debug disabled.
Command Modes EXEC Privilege
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
Service Provider Bridging 2017