Dell C9000 series, Reference Manual

Page: 1581 / 2286

Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.1 Introduced on the S4810.
Usage Information Neighbor Discovery Protocol for IPv6 is defined in RFC 2461 as part of the Stateless
Address Autoconfiguration protocol. It replaces the Address Resolution Protocol used
with IPv4. It defines mechanisms for solving problems, such as:
• Router discovery: Hosts can locate routers residing on a link
• Prefix discovery: Hosts can discover address prefixes for the link.
• Parameter discovery
• Address autoconfiguration — configuration of addresses for an interface
• Address resolution — mapping from IP address to link-layer address
• Next-hop determination• Neighbor Unreachability Detection (NUD): Determine
that a neighbor is no longer reachable on the link
• Duplicate Address Detection (DAD): Allow a node to check whether a proposed
address is already in use.
• Redirect: The router can inform a node about a better first-hop.
Use the ipv6 neighbor command to manually configure the IPv6 address of a neighbor
to be discovered by the switch.
NOTE: The parameters vrf, mac-address, interface are not supported in the batch
mode.
ipv6 ospf area
Enable IPv6 OSPF on an interface.
C9000 Series
Syntax
ipv6 ospf process id area area id
To disable OSPFv6 routing for an interface, use the
no ipv6 ospf process-id
area area-id
command.
Open Shortest Path First (OSPFv2 and OSPFv3) 1581