Dell C9000 series, Reference Manual

Page: 345 / 2286

Parameters
access-list-name Enter a text string as the MAC access list name, up to 140
characters.
cpu-qos Enter the keyword
cpu-qos
to configure an extended MAC ACL
to be used only to filter protocol traffic for control-plane
policing (CoPP).
Defaults none
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.10(0.0) Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior
to 7.8.1.0, names were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
Usage Information The number of entries allowed per ACL is hardware-dependent. For detailed
specifications on entries allowed per ACL, refer to your line card documentation.
If you configure an extended MAC ACL to be used only to filter protocol traffic for
CoPP, you must enter the keyword
cpu-qos
.
Use this command in Configuration Terminal Batch mode to configure an extended
MAC access control list in a dual-homing setup.
Example
Dell(conf)#mac-access-list access-list extended TestMATExt
Dell(config-ext-macl)#remark 5 IPv4
Dell(config-ext-macl)#seq 10 permit any any ev2 eq 800 count bytes
Access Control Lists (ACL) 345