Dell C9000 series, Reference Manual

Page: 110 / 2286

ipv6-address (OPTIONAL) Enter the IPv6 address, in the x:x:x:x::x format, to
which you are testing connectivity.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
count Enter the number of echo packets to be sent. The default is 5 .
• number: from 1 to 2147483647
• continuous: transmit echo request continuously
datagram size Enter the ICMP datagram size. The range is from 36 to 15360
bytes. The default is
100 .
timeout Enter the interval to wait for an echo reply before timing out.
The range is from 0 to 3600 seconds. The default is
2 seconds .
source Enter the IPv4 or IPv6 source ip address or the source interface.
For IPv6 addresses, you may enter global addresses only. Enter
the IP address in A.B.C.D format.
• For a Port Channel interface, enter the keyword
port-
channel
then a number: The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For a Tunnel interface, enter the keyword
tunnel
then a
number from 1 to 16383.
• For a VLAN interface, enter the keyword
vlan
then a
number from 1 to 4094.
tos (IPv4 only) Enter the type of service required. The range is from
0 to 255. The default is
0 .
df-bit (IPv4 only) Enter
Y
or
N
for the “don't fragment” bit in IPv4
header.
•
N
: Do not set the “don't fragment” bit.
•
Y
: Do set “don't fragment” bit
Default is No .
validate-reply (IPv4 only) Enter
Y
or
N
for reply validation.
•
N
: Do not validate reply data.
•
Y
: Do validate reply data.
Default is
No
.
outgoing-
interface (IPv6 link-local address) Enter the outgoing interface for ping
packets to a destination link-local address.
Control and Monitoring 110