Dell C9000 series, Reference Manual

Page: 1805 / 2286

Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added the
DSCP Marking
option support on the S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.5.1.0 Added support for the
DSCP Marking
option.
6.1.1.1 Introduced on the E-Series.
Usage Information To access this command, enter the
class-map
command. After the class map is
identified, you can configure the match criteria. For class-map match-any, a maximum
of five ACL match criteria are allowed. For
class-map match-all
, only one ACL
match criteria is allowed.
Related
Commands
class-map — identifies the class map.
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
C9000 Series
Syntax
match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-dscp value |
set-color value ]
To remove a DSCP value as a match criteria, use the
no match {ip | ipv6 | ip-
any} dscp dscp-list [[multicast] set-ip-dscp value | set-color
value ]
command.
Quality of Service (QoS) 1805