Multicast
The multicast commands are supported by Dell Networking operating system.
This chapter contains the following sections:
•
NOTE:
Dell Networking OS supports Multicast routing only on default VRFs .
IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast
(PIM) tree information base, use the
clear ip pim tib
command.
C9000 Series
Syntax
clear ip mroute {
group-address
[
source-address
] | * | snooping}
Parameters
group-address
[
source-address
]
Enter the multicast group address and source address (if
desired), in dotted decimal format, to clear information on a
specific group.
*
Enter * to clear all multicast routes.
snooping
Enter the keyword
snooping
to delete multicast snooping route
table entries.
Command Modes
EXEC Privilege
Command History This guide is platform-specific. For command information about other platforms, see
the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
32
Multicast
1393
Summary of Contents for C9000 series
Page 1: ...Dell Networking Command Line Reference Guide for the C9000 Series Version 9 10 0 0 ...
Page 394: ...deny 14551 666 Dell Access Control Lists ACL 394 ...
Page 877: ...algorithm FIPS Cryptography 877 ...
Page 1297: ...Total 5 0 Total 5 active route s using 952 bytes IPv6 Basics 1297 ...
