Dell C9000 series, Reference Manual

Page: 493 / 2286

Parameters
ip-address Enter the IP address of the peer router in dotted decimal format.
peer-group-name Enter the name of the peer group to disable all routers within
the peer group.
weight Enter a number as the weight. The range is from 0 to 65535. The
default is
0 .
Defaults 0
Command Modes ROUTER BGP
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information In the best path selection process, the path with the highest weight value is preferred.
NOTE: In the best-path selection process, the path with the highest weight value
is preferred.
If you configure the
set weight
command in a route map applied to this neighbor,
the weight set in that command overrides the weight set in the
neighbor weight
command.
Related
Commands set weight — assigns a weight to all paths meeting the route map criteria.
network
Specify the networks for the BGP process and enter them in the BGP routing table.
C9000 Series
Syntax
network ip-address mask [route-map map-name ]
Border Gateway Protocol 493