Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the VRRP state of a VLAN interface
may continually switch between Master and Backup.
NOTE:
For more information, refer to
and VLAN-related commands, such as
chapter.
default vlan-id
Specify a VLAN as the Default VLAN.
C9000 Series
Syntax
default vlan-id
vlan-id
To remove the default VLAN status from a VLAN and VLAN 1 does not exist, use the
no
default vlan-id
vlan-id
syntax.
Parameters
vlan-id
Enter the VLAN ID number of the VLAN to become the new
Default VLAN. The range is from 1 to 4094. The default is
1
.
Defaults
The Default VLAN is VLAN
1
.
Command Modes
CONFIGURATION
CONFIGURATION TERMINAL BATCH
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant
Dell Networking OS Command Line Reference Guide
.
The following is a list of the Dell Networking OS version history for this command.
Version
Description
9.10(0.0)
Introduced the Configuration Terminal Batch mode on C9010.
9.9(0.0)
Introduced on the C9010.
9.2(1.0)
Introduced on the Z9500.
8.3.19.0
Introduced on the S4820T.
8.3.11.1
Introduced on the Z9000.
8.3.7.0
Introduced on the S4810.
7.6.1.0
Introduced on the S-Series.
7.5.1.0
Introduced on the C-Series.
6.2.1.1
Introduced on the E-Series.
Layer 2
1328
Summary of Contents for C9000 series
Page 1: ...Dell Networking Command Line Reference Guide for the C9000 Series Version 9 10 0 0 ...
Page 394: ...deny 14551 666 Dell Access Control Lists ACL 394 ...
Page 877: ...algorithm FIPS Cryptography 877 ...
Page 1297: ...Total 5 0 Total 5 active route s using 952 bytes IPv6 Basics 1297 ...