Dell C9000 series, Reference Manual

Page: 2183 / 2286

Parameters
ip-address Enter the source IPv4 address in A.B.C.D format.
ipv6–address Enter the source IPv6 address in X:X:X:X::X format.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or
A.B.C.D to match a range of remote addresses. The default mask
is /32 for IPv4 addresses and /128 for IPv6 addresses, which
match only the specified address.
Defaults If you do not configure tunnel allow remote , all traffic which is destined to tunnel
source address is decapsulated.
Command Modes INTERFACE TUNNEL
Command History
Version Description
9.9(0.0) Introduced on the C9010.
9.7(0.0) Introduced on the S6000-ON.
9.3(0.1) Introduced on the S6000 and Z9000.
9.4(0.0) Introduced on the S4810, S4820T, S6000 and Z9000.
Usage Information You can configure up to eight allow-remote entries on any multipoint receive-only
tunnel.
This command fails if the address family entered does not match the outer header
address family of the tunnel mode, tunnel source, or any other tunnel allow-remote.
If you configure any allow-remote , the tunnel source or tunnel mode commands fail if
the outer header address family does not match that of the configured allow-remote.
tunnel destination
Set a destination endpoint for the tunnel.
C9000 Series
Syntax
tunnel destination { ip-address | ipv6–address }
To delete a tunnel destination address, use the
no tunnel destination { ip-
address | ipv6–address }
command.
Parameters
ip-address Enter the destination IPv4 address for the tunnel.
Tunneling Commands 2183