Dell C9000 series, Reference Manual

Page: 273 / 2286

vlan vlan-id (OPTIONAL) Enter the keyword
vlan
then the ID numbers of the
VLANs. The range is from 1 to 4094 (you can use IDs from 1 to
4094).
Defaults Not enabled.
Command Modes INTERFACE
Command History This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series ExaScale.
7.8.1.0 Increased the name string to accept up to 140 characters. Prior
to 7.8.1.0, names were up to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.2.1.1 Introduced on the E-Series.
Usage Information You can assign one ACL (standard or extended ACL) to an interface.
NOTE: This command supports Loopback interfaces EE3 and EF series route
processor modules (RPMs). This command does not support Loopback interfaces
ED series RPMs, C-Series or S-Series Loopback interfaces.
When you apply an ACL that filters IGMP traffic, all IGMP traffic is redirected to the
CPUs and soft-forwarded, if necessary, in the following scenarios:
• on a Layer 2 interface — if a Layer 3 ACL is applied to the interface
• on a Layer 3 port or on a Layer 2/Layer 3 port
Related
Commands
ip access-list standard — configures a standard ACL.
ip access-list extended — configures an extended ACL.
Access Control Lists (ACL) 273