management route
Configure a static route that points to the Management interface or a forwarding router.
C9000 Series
Syntax
management route {{
ip-address mask
| {
ipv6-address prefix-length
}}
{
forwarding-router-address
| managementethernet | fortyGigE | vlan
| gigabitethernet | tengigabitethernet}}
To remove a static route, use the
no management route{{
ip-address mask
|
{
ipv6-address prefix-length
}}{
forwarding-router-address
|
managementethernet | fortyGigE | vlan | gigabitethernet |
tengigabitethernet}}
command.
Parameters
ip-address mask
Enter an IP address (dotted decimal format) and mask (/prefix
format) of the destination subnet.
ipv6-address
prefix-length
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix
format) of the destination subnet. Enter the IPv6 address in the
x:x:x:x::x format followed by the prefix length in the /x format.
The range is from /0 to /128.
NOTE:
The :: notation specifies successive hexadecimal
fields of zeros.
forwarding-
router-address
Enter an IP address (dotted decimal format) or an IPv6 address
(x:x:x:x::x format) of a forwarding router.
managementethe
rnet
Enter the keyword
managementethernet
for the Management
interface on the Primary RPM.
fortyGigE
Enter the keyword
fortyGigE
to specify a forty Gigbit Ethernet
interface.
vlan
Enter the keyword
vlan
to specify a vlan interface.
gigbitethernet
Enter the keyword
gigabitethernet
to specify a one Gigabit
Ethernet interface.
tengigabitethernet Enter the keyword tengigabitethernet to specify a ten Gigabit
Ethernete interface.
Defaults
Not configured.
Command Modes
CONFIGURATION
IPv4 Routing
1207
Summary of Contents for C9000 series
Page 1: ...Dell Networking Command Line Reference Guide for the C9000 Series Version 9 10 0 0 ...
Page 394: ...deny 14551 666 Dell Access Control Lists ACL 394 ...
Page 877: ...algorithm FIPS Cryptography 877 ...
Page 1297: ...Total 5 0 Total 5 active route s using 952 bytes IPv6 Basics 1297 ...
