Dell C9000 series, Reference Manual

Page: 57 / 2286

Configuration Terminal Batch Mode
To set up common configurations on a port extender connected in a dual homing environment, use
Configuration Terminal Batch mode.
To enter Configuration Terminal Batch mode:
1 Verify that you are logged in to EXEC Privilege mode.
2 Enter the
configure terminal batch
command. The prompt changes to include (conf-b).
You can return to EXEC mode by using the
exit
command.
CONTROL-PLANE Mode
To manage control-plane traffic, use CONTROL-PLANE mode. For more information, see
Control Plane Policing (CoPP) .
To enter CONTROL-PLANE mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the
control-plane-cpuqos
command. The prompt changes to include (conf-control-cpuqos).
You can return to CONFIGURATION mode by using the
exit
command.
DHCP Mode
To enable and configure Dynamic Host Configuration Protocol (DHCP), use DHCP mode. For more
information, see
Dynamic Host Configuration Protocol (DHCP) .
To enter DHCP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the
ip dhcp server
command. The prompt changes to include (config-dhcp).
You can return to CONFIGURATION mode by using the
exit
command.
DHCP POOL Mode
To create an address pool, use DHCP POOL mode. For more information, see
Dynamic Host Configuration Protocol (DHCP) .
To enter DHCP POOL mode:
1 Verify that you are logged in to DHCP mode.
2 Enter the
pool
command then the pool name. The prompt changes to include (config-dhcp- pool-
name ).
You can return to DHCP mode by using the
exit
command.
CLI Basics 57