Dell C9000 series, Reference Manual

Page: 910 / 2286

Parameters
lincard slot-id / all Enter the keyword
linecard
with the slot-id to specify a
linecard, or
all
to select all linecards. Linecard ID. Range is
from 0 to 11.
pe pe-id / all Enter the keyword
pe
and the port extender ID or type the
option
all
to select all port extenders. Range is from 0 to 255.
stack unit unit-
number
Enter the keyword
stack-unit
and the configuration is applied
to all the stack-units present in the PE.
rpm Enter the keyword
rpm
to disable auto-reboot of the failed RPM.
Default Disabled (that is, the failed module is automatically rebooted).
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(0.0) Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.3.1.0 Added the
all
option.
8.1.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the E-Series
Usage Information Enabling this command keeps the failed module (RPM, PE, or Linecard) in the failed
state. If there are two RPMs or PEs in the system, enabling this command prevents the
failed RPM or PE from becoming a working Standby RPM or PE. If there is only one RPM
or PE in the system, the failed RPM or PE does not recover and affects the system.
Example: PE
Dell(conf)#redundancy disable-auto-reboot pe 1 stack-unit
High Availability (HA) 910