Dell C9000 series, Reference Manual

Page: 2283 / 2286

vlan-stack protocol-type
Define the stackable VLAN tag protocol identifier (TPID) for the outer VLAN tag (also called the VMAN tag). If
you do not configure this command, the system assigns the value 0x9100.
C9000 Series
Syntax
vlan-stack protocol-type number
Parameters
number Enter the hexadecimal number as the stackable VLAN tag.
You may specify both bytes of the 2-byte S-Tag TPID. The range
is from 0 to FFFF. The default is
9100 .
Defaults 0x9100
Command Modes CONFIGURATION
Command History This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide .
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.9(0.0) Introduced on the C9010.
9.2(1.0) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series ExaScale. C-Series and S-Series
accept both bytes of the 2-byte S-Tag TPID.
8.2.1.0 Introduced on the E-Series ExaScale.
7.6.1.0 Introduced on the C-Series and S-Series.
Usage Information For specific interoperability limitations regarding the S-Tag TPID, see the
Dell
Networking OS Configuration Guide .
The four characters you enter in the CLI for number are interpreted, as shown in the
following table.
VLAN Stacking 2283