Siemens 6MD85, Manual

Page: 1151 / 1256

V
thresh
Threshold value (parameter
Threshold
)
k Curve constant k (parameter
Charact. constant k
)
α Curve constant α (parameter
Charact. constant α
)
c Curve constant c (parameter
Charact. constant c
)
Dropout
The greater dropout differential (=
| pickup value – dropout value |
) of the following 2 criteria
applies:
Dropout differential derived from the parameter
Dropout ratio
If this parameter is not available, a dropout ratio of 95 % applies for the overvoltage and of 105 % for the
undervoltage functionality.
Minimum absolute dropout differential
150 mV sec.
Times
Operate time with time delay = 0 ms
Approx. 25 ms + OOT 70 at 50 Hz
Approx. 22 ms + OOT at 60 Hz
Dropout time Approx. 20 ms + OOT
Frequency Operating Range
0.9 ≤ f/f
rated
≤ 1.1 According to specified tolerances
10 Hz ≤ f < 0.9 f
rated
1.1 f
rated
< f ≤ 80 Hz
Slightly expanded tolerances
f < 10 Hz
f > 80 Hz Active
Tolerances for Stage Type Definite-Time Overvoltage Protection
Voltages 0.5 % of the setting value or 0.05 V
Time delays 1 % of the setting value or 10 ms
Tolerances for Stage Type Inverse-Time Overvoltage Protection
Voltages 0.5 % of the setting value or 0.05 V
Operate time for
1.2 ≤ V/V threshold value ≤ 20 5 % of the setting value or 30 ms
Reset time delay 1 % of the setting value or 10 ms
70 OOT (Output Operating Time): additional delay of the output medium used, see chapter 11.1.4 Relay Outputs
Technical Data
11.17 Overvoltage Protection with 3-Phase Voltage
SIPROTEC 5, High-Voltage Bay Controller, Manual 1151
C53000-G5040-C015-9, Edition 11.2017