Foundry NetIron M2404C and M2404F Metro Access Switches
Configuring SAA via SNMP (Rev. 01)
Configuration Examples
© 2008 Foundry Networks, Inc
Page 33 of 40
Configuration Examples
In the following example an H-VPLS service is configured between
Device1
and
Device3
. The
SAA is used for performance monitoring of SLA parameters from
Device1
to
Device3
, see
Figure
11
.
This example also demonstrates unqualified configuration with specific uplink ports 1/1/27 and
1/1/28.
NOTE
The H-VPLS environment should be configured for Device1 and Device3. For
additional information regarding the H-VPLS configuration please refer to the
“Configuring MPLS and H-VPLS” chapter.
Figure 11: Performance monitoring of SLA parameters from Device1 to Device3
Configuration via CLI
Create an SAA Threshold Profile and Configure an SAA Test on Device1:
1. Create an SAA threshold profile and set the jitter-error threshold value, latency-error threshold
value and frame-loss-error threshold value:
Device1
(config)#
saa profile 1 Profile
Device1
(config-saa-profile)#
jitter-error 20
Device1
(config-saa-profile)#
latency-error 200
Device1
(config-saa-profile)#
frame-loss-error 5.0
Device1
(config-saa-profile)#
exit