Foundry NetIron M2404C and M2404F Metro Access Switches
Configuring MPLS and H-VPLS (Rev. 03)
Resource Reservation Protocol Traffic Engineering (RSVP-TE)© 2008 Foundry Networks, Inc
Page 93 of 113
Figure 17: RSVP-TE FRR in Ring Topology
Configuring IP Interfaces
Configure one loopback and two logical IP interfaces on each device. The selected logical
interfaces will be used as uplinks ports between the devices. The loopback interface (with
permanent
UP
status) will be used for LDP signalization.
Configuring
deviceA
:
deviceA
#
configure terminal
deviceA
(config)#
interface sw1
deviceA
(config-if sw1)#
ip address 11.0.0.1/8
deviceA
(config-if sw1)#
mpls rsvp
deviceA
(config-if sw1)#
ospf hello-interval 1
deviceA
(config-if sw1)#
ospf dead-interval 3
deviceA
(config-if sw1)#
exit
deviceA
(config)#
interface sw2
deviceA
(config-if sw2)#
ip address 12.0.0.2/8
deviceA
(config-if sw2)#
mpls rsvp
deviceA
(config-if sw2)#
ospf hello-interval 1
deviceA
(config-if sw2)#
ospf dead-interval 3
deviceA
(config-if sw2)#
exit
deviceA
(config)#
interface lo1
deviceA
(config-if lo1)#
mpls rsvp
deviceA
(config-if lo1)#
ip address 1.1.1.1/32
deviceA
(config-if lo1)#
exit
deviceA
(config)#
vlan
deviceA
(config vlan)#
create v11 11
deviceA
(config vlan)#
create v12 12
deviceA
(config vlan)#
config v11
deviceA
(config-vlan v11)#
add ports 1/1/27 untagged
deviceA
(config-vlan v11)#
add ports default 1/1/27
deviceA
(config-vlan v11)#
rif sw1
deviceA
(config-vlan v11)#
exit