Foundry NetIron M2404C and M2404F Metro Access Switches
Configuring Interfaces (Rev. 03)
Fast Ethernet and Giga Ethernet Port
© 2008 Foundry Networks, Inc.
Page 4 of 57
Parameter
Default Value
Port name
None
Backpressure mode
Disabled
Duplex speed
For Fast Ethernet Fiber: Auto-negotiation.
For Giga Ethernet Fiber: Auto-negotiation.
For Fast Ethernet and Giga Ethernet Copper: Auto-
negotiation.
Flow Control mode
Disabled
Default VLAN
1
Broadcast rate limit
Unlimited
Multicast rate limit
Unlimited
Unknown rate limit
Unlimited
Packet-size limit
Default size is 1528
Remote fault detect
Disabled
Crossover detection
Automatic
Learning new address
Enable
Configuring Fast and Giga Ethernet Port Interfaces
Table 2
lists the Fast and Giga Ethernet Ports configuration commands.
Table 2: Fast and Giga Ethernet Configuration Commands
Command
Description
interface
Enables configuration of a specific physical interface.
interface range
Enables configuration of range of physical interfaces.
shutdown
Disables the interface (to receive, forward and learn).
name
Assigns a name to the Fast Ethernet or Giga Ethernet port to
facilitate device administration.
speed
Specifies the interface speed.
duplex
Sets the port duplex mode.
backpressure
Changes the backpressure mode.
flow-control
Changes the flow control mode.
default vlan
Changes the default VLAN (PVID) of the configured interface.
broadcast-limit
Sets a limit to the broadcast rate on the configured interface.
multicast-limit
Sets a limit to the multicast rate on the configured interface.
unknown-limit
Sets a limit to the rate of the Layer-2 unknown packets on the
configured interface.