![background image](http://html1.mh-extra.com/html/foundry-networks/netiron-m2404c/netiron-m2404c_user-manual_2324273402.webp)
Foundry NetIron M2404C and M2404F Metro Access Switches
Configuring SNMP (Rev. 03)
Simple Network Management Protocol
© 2008 Foundry Networks, Inc.
Page 26 of 48
Argument Value
Description
saaThresholdCrossed
This notification is generated when a SAA
monitored parameter is detected to have crossed
preconfigured threshold in any direction, raising
or falling.
batmDuplicatedMACAddressAlarm
This notification is sent once the duplicate MAC
address, per VLAN, is learned on different port.
It includes information for: status of the MAC
address, status of the vlan, status of previous
port on which this MAC has been learned.
Configuring the SNMP Notification Log
The
snmp-server log-notify
command in Global Configuration mode, enables the SNMP
notification log. The
no
form of this command disables the SNMP notification log and clears its
contents.
When the command is used without arguments, it enables logging all notifications to the internal
Flash memory. A log entry will be created for each notification as it occurs, regardless of whether
a trap has been sent or not.
NOTE
If the user disables notifications associated with a specific tag name, by specifying
the tag name in the
no snmp-server log-notify
command, the general
snmp-server
log-notify
command (without the specific tag name) will not enable these
notifications. In this case, the user has to explicitly enable these notifications.
For example, if the user has set
no snmp-server log-notify
Tag1
then using
snmp-
server log-notify
will enable all notifications except for those associated with
Tag1.
To enable the notifications that are associated with
Tag1
, use
snmp-server log-
notify
Tag1
.
By default, the SNMP notification log is disabled.
Command Syntax
device-name
(config)#
snmp-server log-notify
[
TAG-NAME
]
device-name
(config)#
no
snmp-server log-notify
[
TAG-NAME
]
Argument Description
TAG-NAME
(Optional). Name of the tag associated with the notifications to be logged. If
the parameter is not supplied, logging of all notifications is enabled/disabled.
The available names of notifications are specified in
Table 5
.
Configuring SNMP Logging of Sent Notifications
The
snmp-server log-sent-notify
command, in Global Configuration mode, enables logging only
of notifications that are sent to management stations. The
no
form of this command disables the
SNMP sent-notification logging. The command causes the addition of a trap sequence ID based on
the request ID field of the SNMP trap packet. The addition of the sequence ID changes the
behavior of the SNMP notification log by logging notifications in the order at which they are sent.