Foundry NetIron M2404C and M2404F Metro Access Switches
Configuring MPLS and H-VPLS (Rev. 03)
Multiprotocol Label Switching
© 2008 Foundry Networks, Inc
Page 30 of 113
Argument Description
NAME
The name of the LSP. The name should be composed of up to 20 characters.
Shutting Down LSPs
The
shutdown
command, in LSP Configuration mode, administratively disables an LSP.
The
no
form of this command enables the LSP.
By default LSPs are not shut down.
Command Syntax
device-name
(config-lsp-
NAME
)#
shutdown
device-name
(config-lsp-
NAME
)#
no shutdown
Setting LSP Committed Rate
The
commit-rate
command, in LSP Configuration mode, specifies the average rate on the LSP.
The
no
form of the command removes any value previously defined.
Command Syntax
device-name
(config-lsp-
NAME
)
#
commit-rate <1-1000000>
device-name
(config-lsp-
NAME
)
#
no commit-rate
Argument Description
1-1000000
The average rate in kbps.
Setting LSP Peak Rate
The
peak-rate
command, in LSP Configuration mode, specifies the maximum rate on the LSP in
kilobits per second. The
no
form is used to remove any previously defined value.
By default no maximum rate is defined.
Command Syntax
device-name
(config-lsp-
NAME
)
#
peak-rate <1-1000000>
device-name
(config-lsp-
NAME
)
#
no peak-rate
Argument Description
1-1000000
The maximum rate in kbps.
Setting LSP Ingress LSR ID
The
ingress-lsr-id
command, in LSP Configuration mode, defines an ingress LSR ID for a specific
LSP. To change the
ingress-lsr-id
execute the same command again using a different parameter.
By default no ingress ID value is defined.