Omron CS1W-MCH71 -, Руководство по эксплуатации

Страница: 702 / 717

657
Error Log
Section 11-9
Error code The error codes are classified into the CPU errors and MC Unit errors.
CPU Error Codes
Error
code
(Hex)
Error name Detailed code Cause
1st byte 2nd byte
0001 CPU WDT error 00 00 The watchdog timer alarm occurred on CPU
Unit.
Provide remedy following instructions in the
manual of the CPU Unit.
0002 CPU cyclic ser-
vice monitor error Monitor time (ms) Time out of the cyclic monitor time.
The followings are the possible causes:
• End refresh is prohibited on CPU Unit.
• The scan time of CPU Unit is too long.
Remedies:
Enable end refresh
Set the longer cyclic monitor time.
000E CPU bus error 00 00 CPU Unit Bus error
0015 Fatal CPU error 00 00 Fatal error occurred on CPU Unit.
Check if MC Unit is mounted on the backplane
correctly. If the error persists even after the
checking and correction, CPU Unit or the back-
plane may be broken. Replace it as needed.
0016 Non-fatal CPU
error 00 00 Non-fatal error occurred on CPU Unit.
Provide remedy following instructions in the
manual of CPU Unit.
0108 Routing error In a command:
When SNA < 80
Hex
D7:OFF
D6 to D0:SNA
SNA> = 80Hex
D7:OFF
D6 to D0:0
In a response:
When DNA<80Hex
D7:ON
D6 to D0:DNA
DNA> = 80Hex
D7:ON
D6 to D0:0
D7 to D0:SA1
D7 to D0:SNA
(SNA> = 80Hex)
D7 to D0:DA1
D7 to D0:DNA
(DNA> = 80Hex)
Transfer not possible because there is no Unit
for the specified unit number
Normally, this error does not occur. If it should
occur, report to OMRON.
010D Routing error Transfer not possible because the destination
address in the routing table has not been set.
Normally, this error does not occur. If it should
occur, report to OMRON.
010E Routing error Transfer not possible because of a routing table
error.
Normally, this error does not occur. If it should
occur, report to OMRON.
0118 Incorrect packet
error An incorrect packet has been transferred.
Normally, this error does not occur. If it should
occur, report to OMRON.
0124 Routing error Routing not possible because the maximum
frame length has been exceeded.
Normally, this error does not occur. If it should
occur, report to OMRON.
0601 Panic generated Panic data Set if trap processing has been executed.
Normally, this error does not occur. If it should
occur, report to OMRON.