Omron CS1W-MCH71 -, Руководство по эксплуатации

Страница: 486 / 717

441
Interface Specifics
Section 7-4
• The bit [Unit Ready] will be turned ON after the power is turned ON, the
initial processing is completed, and the motion task becomes ready to
receive commands.
• During normal operations, the bit [Unit Ready] will be turned OFF when
an alarm that requires the system stop occurs.
Effect on Other Functions • When the bit [Unit Ready] is OFF, all the commands from the cyclic area
will be ignored.
• Whether the motion program can be actually executed or not depends on
the bit [Command Disabled/Enabled] of the axis declared by PROG com-
mand.
System Parameters Nil
Program Example The MC Unit supports processing of great amounts of data and varieties of
peripheral devices to realize multi-axis applications. Due to the fact, it takes
the MC Unit a certain period of time (8 seconds min.) to get ready for opera-
tion.
Additionally, the MC Unit and CPU Unit establish communications asynchro-
nously. To make the MC Unit receive instructions from PLC without fail, make
sure to send instructions from the CPU Unit to the MC Unit when the bit [Unit
Ready] is ON.
<Example of always using Task 1 and 2 as start tasks>
Note Programs (for arithmetic operation, etc.) that do not use axes may start
motion tasks with the bit [Unit Ready], however, programs that use axes
require interlock for the used axes as shown above.
Timing Chart Nil
Function The bit [External Forced Stop Request] indicates the occurrence of a forced
stop request from something other than the input variable. The bit [External
Forced Stop Status] indicates the status of the stop caused by a forced stop
request.
n+15.00
x+32 to 63.03
n+15.00 +0 to 31.15
x+32 to 63.13
Unit Ready
Unit Ready
In Automatic
Mode In Servo Lock Command
Disabled/
Enabled
n+4.01
Motion Task 1 Start
n+5.01
Motion Task 2 Start
Interlock
Word Variable Bit Name I/O
n+15 OW0303 07 External Forced Stop Request Input
08 External Forced Stop Status Input