Omron CS1W-MCH71 -, Руководство по эксплуатации

Страница: 515 / 717

470
Interface Specifics
Section 7-4
Effect of Other Functions Nil
System Parameter ON/OFF of the bit [Speed Clamp Warning] is determined by the following sys-
tem parameters:
Timing Chart Basic Operation:
Function The bit [Start Warning] indicates the status that the execution start condition
was not satisfied when starting motion program execution
.
Status Condition
• The bit [Start Warning] is turned ON in the following cases and it will be
turned OFF when motion program operation is started successfully.
• The bit [Deceleration Stop] or [Block Stop] is ON.
Parameter No. Name
P00M01 Maximum interpolation feed rate
P2AA01 Maximum rapid feed rate
1
0
0
200.00% 100.00% 100.00%
T1 T1
The override exceeded 100% and the bit
[Speed Clamp Warning] was turned ON. Override reduced to 100% and the bit
[Speed Clamp Warning] was turned OFF.
Speed
Maximum rapid feed rate
Time
Axis Control Data:
Axis Override
Axis Status Bit:
Speed Clamp Warning
Word Variable Bit Name I/O
n+17
-
n+24 OW0340
-
OW0347 05 Start Warning (Task 1)
-
Start Warning (Task 8) Input
Name Specifications
Start Warning 0: Started motion program operation successfully.
1: Could not start motion program operation (Axis declaration,
Axis mode)