Omron CS1W-MCH71 -, Руководство по эксплуатации

Страница: 690 / 717

645
Motion Task-related Alarm Codes
Section 11-5
Mode specifi-
cation error 0372h
-
0379h 200Eh 200Eh The following operand has exceeded the
range.
• Q (MOVEC, MOVETRAV, MOVELINK,
CAMBOX)
Correct the applicable operands.
When a
command
including an
operand is
executed. Deceler-
ation
stop Enabled
Other oper-
and error 200Fh 200Fh The following operands have exceeded the
range.
• K (CAM, CAMBOX)
• B (MOVELINK, CAMBOX, CONNECT,
SYNC, ADDAX)
• TORQUE
• SIN, COS, ASIN, ACOS, SQT, LGN, BIN,
BCD
Correct the applicable operands.
When a
command
including an
operand is
executed. Deceler-
ation
stop Enabled
--- 2010h 2010h --- --- --- ---
Circular inter-
polation travel
distance over 2011h 2011h Travel distance specified in MOVEC is too
great.
• The tangent arc length has exceeded
2147483647. Check the program and cor-
rect the setting value so that it will not
exceed the allowable range. (When speci-
fying with variables, check if the substitu-
tion formula is correct.)
• The radius has exceeded 2147483647.
Check the program and correct the setting
value so that it will not exceed the allow-
able range. (When specifying with vari-
ables, check if the substitution formula is
correct.)
When
MOVEC is
executed. Deceler-
ation
stop Enabled
Circular inter-
polation
radius error 2012h 2012h The following instructions have been given
in MOVEC.
In Radius specification: The radius is specified to
0.
• Check the program and correct the radius
to the value larger than 0. (When specify-
ing with variables, check if the substitution
formula is correct.)
• In Center specification: The start or end
point, and the center are at the same posi-
tion.
Check the program and correct it so that the
start or end position are not on the center.
When
MOVEC is
executed. Deceler-
ation
stop Enabled
Name Error log Alarm
code
Cause and remedy Timing Rank Reset
Error
code
Detail
code