Omron CS1W-MCH71 -, Руководство по эксплуатации

Страница: 350 / 717

305
Command Details
Section 6-3
• In radius specification, if [Radius] is positive, the center angle will be 180
degrees or smaller. If [Radius] is negative, the center angle will be 180
degrees or greater.
• MOVEC command execution will be completed (or No.2 in-position com-
plete) when the travel distance command output for all specified axes is
completed.
• During the command execution, the command code “0003h” is output to
the system variable “Command execution status” (SW0228 for Axis 1).
(For details of command codes, see
4-5 System Variables Command
Code in Command Execution Status on page 158.)
• When a circular arc cannot be drawn with the specified radius or center
position, the radius is compensated to draw the arc. Having the radius in
radius specification or the radius calculated with center specification as
the initial value, the radius is increased to accomplish the radius at the
end position along the rotating angle.
• When executing circular interpolation on the axis with S-curve filter set-
ting, an arc larger than the specified arc may be drawn. The greater the S-
curve time constant is, the greater the overshoot amount (= Specified arc
- Actual arc) will be. Operate only after thorough adjustment is made.
Origin Search
(DATUM)
The DATUM command performs an origin search for the specified axis.
Command type Single execution command
Format DATUM_[<axis name>]<offset value> ---8---;
Ex: DATUM_[J01]0 [J02]0;
Operand Axis name: J01 to J32
Note (1) Word data is extended to long word data with a sign in the MC Unit.
(2) The actual value is determined by the setting value of the parameter
[P5AA02: Position command decimal point position].
(3) There is no influence. ABL specification is always used.
Radius < 0
End position
180 degrees
or smaller
Radius > 0
180 degrees
or greater
Start position
Operand Setting range Decimal Variable specification INC/ ABL
influ-
ence
Bit Word Long
word
Real
number
Indirect
specifi-
cation
Offset value
−
2147483648 to
2147483647
Yes No Yes (See
note 1.) Yes Yes (See
note 2.) Yes No (See
note 3.)