Omron CS1W-MCH71 -, Руководство по эксплуатации

Страница: 516 / 717

471
Interface Specifics
Section 7-4
• [Motion Program Number] is not between 0-499.
• The motion program specified by [Motion Program Number] does not
exist (It has not been loaded).
• The bit [Command Disable/Enable] of the axis specified by PROG com-
mand is OFF.
• The bit [Axis Not Used/Used] of the axis specified by PROG command is
ON.
• The bit [Manual/Automatic Mode] of the axis specified by PROG com-
mand is OFF.
• A unit alarm, motion task alarm, or an alarm of the axis specified by
PROG command is occurring, or the bit [External Forced Stop Request] is
ON.
Effect on Other Functions Nil
System Parameter Nil
Timing Chart
Function The bit [Start] indicates the ON/OFF status of the bit [Motion Program Operat-
ing].
Status Condition
0 200
600 200
1
0
1
0
1
0
T1
T1
No.600 is outside of the range.
Therefore, it is not executed and the
bit [Start Warning] is turned ON. Program operation was started
successfully and the bit [Start
Warning] is turned OFF.
Motion Task Control Bit:
Motion Program Start
Motion Task Control Data:
Motion Program Number
Motion Task Status Bit:
Motion Program Operating
Motion Task Status Bit:
Start Warning
Motion Task Status Data:
Executing Motion
Program Number
Word Variable Bit Name I/O
n+17
-
n+24 OW0340
-
OW0347 06 Start Bit (Task 1)
-
Start Bit (Task 8)
(Supported in Unit Ver. 3.0 or later) Input
Name Specifications
Start 0: Motion Program Operating Bit OFF (0).
1: Motion Program Operating Bit ON (1).