NEC SV8500, Manual

Page: 715 / 3438

VOL.2-462
MCMG Card [SCA-7COTA]
Note:
The following SET commands are available for MCMG with the firmware versions: SP-3849 MCMG
PROG-A Issue 9 or later.
COMMAND No. SUB COMMAND FUNCTION REMARKS
SET
(MG side)
1 CAR_DETECT Setting CAR Detection:
2 CODEC_COEF_MG Setting CODEC Coefficiency:
3 DSP_ECFB_MG Setting DSP echo canceller for FAX communication
4 DTMF_CUTOFF_TIME Setting DTMF Cutoff Timer:
5 EC_TRAINING_MG Setting Training feature mode of echo canceller:
6 FAXERRORDETECT_MG Setting FAX enable timer:
7 FAXRECVPAD_MG Setting Fax receiver PAD value:
8 FAXSENDPAD_MG Setting Fax sender PAD value:
9 IC_ABANDON_TIME Setting I/C call abandon timer:
10 NO_LOOP_TIME Setting Loop Prohibition timer:
11 RELEASE_SIGNAL Setting Release Signal:
12 SMOOTH_PAD_MG Setting DSP smooth PAD mode:
13 RVS_AUST Setting RVS mode (for Australia):
14 AUTO_POLARITY Setting Auto Polarity
COMMAND No. SUB COMMAND FUNCTION REMARKS
SET
(MG side)
1 CALL_HOLD Setting MG Based Call Retention
2 RTP_STOP_DETECT
Setting RTP Receive Stop Detect timer used for MG Based
Call Retention