NEC SV8500, Manual

Page: 1757 / 3438

VOL.2-1504
MG-SIP128 [MG-128SIPMGJ]
Note:
When the IP addresses of both LAN and WAN are assigned in the same segment, use Ether1 port
only. Select one port in the number of port setting, and assign Ether1’s IP address only. In this case,
Ether2 is not used. For the MG-SIP128 [MG-128SIPMGJ] where Ether2 is already registered, a
message of “Ether[2]Port data is erased. Are you sure? Y/N” is displayed. To delete the data of
Ether2, enter Y.
[Setting Example]
Note:
The conditions of this command are as follows.
• When the IP addresses of LAN and SIP network sides are assigned in the same segment, use Ether1 only as
shown below.
* If you select one port in the number of port setting, Ether2 setting is not performed.
• If you select one port in the number of port setting, be careful not to use the same RTP port number (set by
“set sip_rtp_port_no” or “set ipx_rtp_port_no” command) when setting the non-default SIP network RTP
base port number.
MG(SIP) > set ipaddress
Do you use one-port only? Y/N=n
Ether[1]
Setting Ether1 port:
Input IP Address.(default=0.0.0.0)
:10.1.0.1 IP address (Default: 0.0.0.0)
Input Subnet mask.(default=0.0.0.0)
:255.255.255.0
Subnet mask (Default: 0.0.0.0)
Ether[2] Setting Ether2 port:
Input IP Address.(default=0.0.0.0)
:192.168.1.1
IP address (Default: 0.0.0.0)
Input Subnet mask.(default=0.0.0.0)
:255.255.255.0 Subnet mask (Default: 0.0.0.0)
Telephony Server
10.0.0.1
MG
-
SIP128
[MG-128SIPMGJ]
Router
10.0.0.254
10.0.0.0/24
Network