NEC SV8500, Manual

Page: 2884 / 3438

VOL.3-397
CHAPTER 4 CONFIGURATION SETUP
1.1 Data Assignment for System having DHCP server - Type 1 [DRS address already
assigned]
The following shows the procedure of DtermIP/IP Enabled Dterm data assignment for a system having DHCP
server [MGC (DRS) address already assigned at the DHCP server]. The procedure assumes that the DHCP serv-
er notifies IP address of IP DtermIP/Enabled Dterm, default gateway, subnet mask, DRS address primary and
secondary (option) (
Note 1
).
Note 1:
About IP address of DRS (Telephony Server), refer to “Registration Destination of IP Devices/Stations” in
INTRODUCTION of Installation Manual.
• When using the DHCP server and Redundancy Configuration System such as SR-MGC, refer to
“2.1.1 Setting for Redundancy Configuration System”.
Caution: Observe the following while performing this procedure:
• Do Not Turn OFF the power of the DtermIP
/ IP Enabled Dterm, the Telephony Server, DHCP
server.
• Do Not Unplug or Plug the LAN cable connecting to the DtermIP / IP Enabled Dterm, the
Telephony Server, DHCP.
• Do Not Turn OFF the power of the HUB connecting to the DtermIP / IP Enabled Dterm, Telephony
Server, DHCP.
STEP 1: Turn ON the Dterm IP/IP Enabled Dterm.
When the terminal is turned ON, it starts setup process with the DRS on the LAN, indicating
"DHCP Connecting..." or "DRS(1st) Connecting..." on the display.
A
1. DHCP Mode
2. DRS Address Primary
Up Down Cancel Save
DHCP Connecting... DRS(1st) Connecting...
STEP 2: While indicating "DHCP Connecting..." or "DRS(1st) Connecting..." on the display,
press "Hold" + "Transfer" + "*" + "#" on the terminal, and open the User Menu.
[User Menu]
or
Ex.)
Note:
When using Backup DRS, "DRS(2nd) Connecting...", "DRS(3rd) Connecting...", or "DRS(4th) Connecting..."
will be displayed instead of "DRS(1st) Connecting...".