NEC SV8500, Manual

Page: 1163 / 3438

VOL.2-910
MG(BRI) [SCA-2BRIA/MG-2BRIA]
Note:
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
followed by the prompt. The meaning of 1-byte data is shown below:
When D: DIFFSERV is selected:
Note:
The result of data setting is shown in a 1-byte (hexadecimal) format in accordance with the setting dialog
followed by the prompt. The meaning of 1-byte data is shown below:
F
VLAN Information set
Assign the VLAN data.
RELIABILITY(0/1: 0):0
Precedence of Reliability in IP network
0: Not specified (Default)
1: Specified
COST(0/1:0):0
Precedence of Lower Cost in IP network
0: Not specified (Default)
1: Specified
QoS [I (IP PRECEDENCE)/D (DIFFSERV): IP PRECEDENCE]:d
DSCP (0-63: 48): 48
Enter DSCP value (0-63)
(Default: 48)
--- VLAN Information set ---
Current VLAN Information:
Current data setting is displayed.
Device ID COS IP Address Subnetmask
VLAN 1 1 7 10.41.1.200 255.255.255.0
Change VLAN Information? [Y (change)/N (current)/
Q(quit)]: y
Asked whether to change the displayed data.
Y: To change the displayed data
N: Not change
Q: Quit Standard mode
Input new VLAN ID (0-4094): 1
VLAN ID: 0-4094
Input new COS (0-7): 6
CoS setting: 0-7
Input new IP Address: 10.41.1.200
Enter the IP address of VLAN.
Input new Subnet mask: 255.255.255.0
Enter the subnet mask of VLAN.
Prec.=PRECEDENCE (3 bits)
D=Delay
T=Throughput
R=Reliability
C=Cost
Prec.
D T R C
DSCP = Differentiated Service Code Point (6 bits)
DSCP