NEC SV8500, Manual

Page: 1446 / 3438

VOL.2-1193
MG(PRI) (2M) [SCA-30PRIA/MG-30PRIA]
• Restoring Config Data via TFTP
<Data Assignment on TFTP Server>
STEP 1
If the name of the backup config file is not sysdata, rename it to “sysdata”.
STEP 2
Put the file in the root folder of TFTP server, and then start the TFTP server program.
STEP 3
Permit read behavior of this folder. For more information, refer to the appropriate manual at-
tached to the TFTP server program.
<Data Assignment on PCPro>
STEP 4
To search for the LENS of the target MG(PRI), use the IPAN command.
STEP 5
To make environment setting for Telnet, use the ATUD command.
- Specify the LENS, which is belonging to the target MG(PRI).
- Specify a user ID and a password, which are required for logging in MG(PRI) via Telnet.
- Input any letter for USER LEVEL because MG(PRI) does not use USERLEVEL.
- For VALID TIME, input a total of time required for completing this procedures.
Note:
A user ID and a password are temporary ones for download; you can specify them as you like
STEP 6
After completing the above, click the Set button.
<Data Assignment on Telnet PC>
STEP 7
Start a command prompt and enter “
telnet <MG(PRI)’s IP Address>
” to connect
MG(PRI) via Telnet.
STEP 8
Log in to the target MG(PRI) by entering userID and password, which are set in the AUTD
command.
IP Network
TFTP Server
Telnet PC
PCPro
SYSTEM
MG(PRI)
(3) Control MG(PRI) via
Telnet
(4) Copy a config file (Backup File)
from TFTP server via TFTP
Configdata
Note 1
Note 1
Note 1
: PCPro and Telnet both can be performed by single Personal Computer.
(2) Make environment setting for Telnet
( 1) Make environment setting for TFTP
B D
ALM PWR
ON
LINE LB
LINE Ether
100M LINK CONSOLE
RESET
MUSIC