NEC SV8500, Manual

Page: 2940 / 3438

VOL.3-453
CHAPTER 4 CONFIGURATION SETUP
1.4.10 How to Send Ping Packet
To send packets from the IP Enabled Dterm by using the Ping command, follow the procedure below.
Note:
When the IP addresses of the terminal and the destination is not set on the IP Enabled Dterm, Ping Packet
cannot be sent.
STEP 1: Open the User Menu by pressing “Hold” + “Transfer” + “*” + “#” on the terminal while indicating
time, an error message, or “DHCP Connecting.../DRS (1st) Connecting...”.
Note:
When using Backup DRS, “DRS(2nd) Connecting...”, “DRS(3rd) Connecting...”, or “DRS(4th) Connect-
ing...” will be displayed instead of “DRS(1st) Connecting...”.
STEP 2: Open the Administrator Menu (Page 1) by pressing “Hold”+“#”+“0” on the User Menu. Select “0.
Next Page (P1 >> P2)” by pressing “0” on the Administrator Menu (Page 1).
STEP 3: The Administrator Menu (Page 2) is displayed. Select “1. Ping” by pressing “1” key.
STEP 4: The following Ping Menu is displayed. Select “2. Destination Address” by pressing “2” key.
Save
1.DHCP Mode
2.DRS Address Primary
Up Down Cancel
[User Menu]
Exit
9.Language
0.Next Page (P1>>P2)
Up Down
[Administrator Menu (Page1)]
1.Ping
2.Music Select
Up Down
[Administrator Menu (Page2)]
1.Echo Request Start
2.Destination Address
Up Down
[Ping Menu]
Exit