NEC SV8500, Manual

Page: 311 / 3438

VOL.2-58
Analog 2MC (Analog Media Converter)
4.3.1 Data Assignment by PCPro
This section shows how to assign basic data via PCPro. By this data assignment, analog terminals connected to
the MC can be used as IP terminals.
[1] Internal PHE Data Assignment
When you use Analog 2MC, control signals between Analog 2MC and the Telephony Server are handled by
Internal PHE, which is embedded in the Telephony Server. So Internal PHE data assignment is necessary. About
the procedure for the Internal PHE data assignment, refer to Vol.1, Chapter 2, “2. IP Related Basic Program-
ming” in this manual. The explanation of PHs including Internal PHE is also there.
[2] Analog 2MC Data Assignment
Assign the system data, according to the station numbering plan. Refer to the following for the prerequisite min-
imum data.
ASYDL:Assignment of System Data (LDM)
SYS1, INDEX 811
Assign the Tone Code by countries. For more information, refer to the Command Manual.
ANPD:Assignment of Numbering Plan
Assign the Access Code (ACC) for station access, by using the combination of ANPD and ASPA com-
mands.
1st DC: Assign the 1st DC of the station numbers.
NND: Assign the total station number digits.
ASPA:Assignment of Special Access Code
ACC: Assign the access code using the 1st DC specified by the ANPD command.
AISTL:Assignment of IP Station Data (LDM)
Assign the IP Station Data of each analog terminal connected to Analog 2MC.
TN: Tenant Number [1-63]
IP STN: Station Number of IP Station (assign the station number for each analog terminal connected to
the Analog 2MC)
KIND: Kind of IP Terminal, select the terminal kind Analog 2MC from the combo box
TEC: Telephone Equipment Class [2,3,14]
Note 1
RSC: Route Restriction Class [0-15]
SFC: Service Feature Restriction Class [0-15]
LENS: IP Station Equipment Number as Virtual LENS. Allocate the IP station to the Virtual LENS
within Virtual PIR, or to the LENS of a vacant slot that Station/Trunk is not mounted (an IP
station cannot be assigned to a registered station multiple times.)
Note 2
MC-ID: ID of the MC (enter the fixed MAC Address of the Analog 2MC)
MC-CH: Channel Number of the MC (assign “0” [Port 0] or “1” [Port 1] for each analog terminal con-
nected to the Analog 2MC)