NEC SV8500, Manual

Page: 716 / 3438

VOL.2-463
MCMG Card [SCA-7COTA]
COMMAND No. SUB COMMAND FUNCTION REMARKS
SHOW
(both MC and
MG sides)
1 DHCP To show DHCP setting:
2 DRSADDRESS To show DRS Address and Port Number:
3 DRSTOS To show ToS setting of DRS session:
4 HC_TIMER To show Health Check Receive Timer
5 INTERFACE To show communication speed for LAN interface:
6 IPADDRESS To show IP Address, Net Mask, and Default Gateway:
7 STARTPORT To show RTP Start Port:
8 VERSION To show the version information:
9 VLAN To show VLAN setting:
10 WARNING_TONE To show Warning Tone control:
COMMAND No. SUB COMMAND FUNCTION REMARKS
SHOW
(MC side)
1 BURSTPATTERN To show Burst Ringer Pattern:
2 CODEC_COEF To show CODEC Coefficiency:
3 DSP_ECFB To show DSP echo canceller for FAX communication:
4 EC_TRAINING To show Training feature mode of echo canceller:
5 FAXERRORDETECT To show Fax enable timer:
6 FAXRECVPAD To show Fax receiver PAD value:
7 FAXSENDPAD To show Fax sender PAD value:
8 MUSICTYPE To show Internal Music-on-Hold type:
9 OPEN To show Open/Reverse mode:
10 PAD To show default receiver PAD value:
11 PRERINGING To show Pre-Ringing:
12 RINGFREQ To show frequency of Ringer:
13 SENDPAD To show default sender PAD value:
14 SMOOTH_PAD To show DSP smooth PAD mode:
15 STUTTERDT To show Stutter Dial Tone:
COMMAND No. SUB COMMAND FUNCTION REMARKS
SHOW
(MG side)
1 CAR_DETECT To show CAR Detection
2 CODEC_COEF_MG To show CODEC Coefficiency
3 DSP_ECFB_MG To show DSP echo canceller for FAX communication
4 DTMF_CUTOFF_TIME To show DTMF Cutoff Timer
5 EC_TRAINING_MG To show Training feature mode of echo canceller:
6 FAXERRORDETECT_MG To show FAX enable timer:
7 FAXRECVPAD_MG To show FAX receiver PAD value:
8 FAXSENDPAD_MG To show FAX sender PAD value:
9 IC_ABANDON_TIME To show I/C call abandon timer:
10 NO_LOOP_TIME To show Loop Prohibition timer
11 RELEASE_SIGNAL To show Release Signal
12 SMOOTH_PAD_MG To show DSP smooth PAD mode
13 RVS_AUST To show RVS mode (for Australia)
14 AUTO_POLARITY To show Auto Polarity