NEC SV8500, Manual

Page: 1887 / 3438

VOL.2-1634
MG-SIP96
Note:
Normally this command is not required to be used.
(15) dnsaddress
Setting of the IP address of DNS server
This command is used to specify the DNS IP address to resolve an address by DNS server.
[Setting Example]
[IPv6]
[IPv4]
Note: You do not have to change this command if you do not use DNS server.
(16) dns_option
Setting of the Optional Data for DNS server
This command is used to enable multiple SIP servers to be supported by DNS server. When IP addresses
of multiple SIP servers are obtained by A record lookup, an alternative route can be used for transmission.
NAPTR lookup (RFC3263) is also enabled.
[Setting Example]
When Locating SIP servers function (RFC3263) (=2) is selected
Config data default set.
MG(SIP)>
MG(SIP)> set dnsaddress
Input DNS IP Address.(default=::)
:2001:db8::820
Specify DNS IP address. (Default: ::)
MG(SIP)> set dnsaddress
Input DNS IP Address.(default=0.0.0.0)
:0.0.0.0
Specify DNS IP address. (Default: 0.0.0.0)
MG(SIP)> set dns_option
Select DNS type
0=A Record resolve(single IP
Address)(default)
1=A Record resolve(multi IP Address)
2=Locating SIP servers function(RFC3263)
Input: 0
Select DNS type. (Default: 0/A Record
resolve (single IP Address))
MG(SIP)> set dns_option