NEC SV8500, Manual

Page: 1614 / 3438

VOL.2-1361
MG-SIP128 [MG-128SIPMGG]
Note 1: Required to set Silent Monitor (Multi-Path Monitor) Connection in the ACD system.
Note 2: Available for SP-4051 MGSIP PROG-G Issue 2 or later.
Note 3: This command cannot be used in combination with the
codec_change
command or “3PCC
function” of the
sip_tel_service
command.
55
sip_tel_service C Assigns the setting of additional services.
56 sip_transport C Specifies a SIP transport protocol.
57
slipresp C Assigns error response codes used when bypassing a SIP server.
58 update C Assigns the setting of update method.
59
country_code C Assigns a country code.
60 multisession C Assigns Multi-path Switch.
Note 1
61
name_display C Enable/disable Name Display service.
62
softdsp
Note 2
C
Note 3
Assigns the setting of A-law/
μ
-law conversion feature and PAD value.
show: Commands to Display the Contents of Configuration Data
SUB COMMAND MUST? FUNCTION
1
arp - Displays the ARP table.
2 config - Displays the configuration data.
3
interface - Displays the link and setting state of Ether connection
4 version - Displays the firmware version installed in MG-SIP128 [MG-128SIPMGG].
5
route - Displays the Route table.
6 status - Displays status of the port and the registration.
download : Command to Download
SUB COMMAND MUST? FUNCTION
1 - - Downloads data from the specified IP address.
exit or logout : Command to Exit the Configuration Mode
SUB COMMAND MUST? FUNCTION
1 - - Exits the configuration mode.
SUB COMMAND MUST? FUNCTION