NEC SV8500, Manual

Page: 2178 / 3438

VOL.2-1925
MG-SIP16 [SCA-16SIPMG(US)]
When “disable” is selected for “SIP Access Filter”, the above settings are not shown.
Note 7:
For SP-3988 MG SIP(16) PROG-G Issue 5 or later, when “enable” is selected for “Burst Access Filter”
by the SET command “sip_accfilter”, “enable” and the following settings are displayed:
Burst Access Filter: enable
Burst Access limit timer value: 30
Burst Access limit number value: 500
Burst Access reject response code: 600
When “disable” is selected for “Burst Access Filter”, the above settings are not shown.
Additional Information when SIP Config Data (=4) is selected:
Item Detail
Server type
“Server IP address” may be displayed as “Server FQDN”, pertaining to the data
assigned.
Register IP Address “Register IP address” may be displayed as “Register FQDN”, pertaining to the
data assigned.
Privacy pattern
Displayed as pattern shown below, pertaining to the data assigned.
“DisplayName”
“Remote-Party-ID”
“RFC3323/3325(0)”
“RFC3323/3325(1)”
Dummy string Displayed only when “Remote-Party-ID” is assigned for “Privacy pattern”.
Session-timer May be displayed “Disabled”, pertaining to the data assigned.
Session-expires Not displayed when the value of “Session-timer” is “disable”.
Refresher Not displayed when the value of “Session-timer” is “disable”.
May be displayed “UAS”, pertaining to the data assigned.
Invite Refresher
Not displayed when the value of “Session-timer” is “disable”.
May be displayed “disabled”, pertaining to the data assigned.
Forced Displayed as “enabled” when Forced section in “session_timer” is assigned as
enabled.
100rel
May be displayed “disabled”, pertaining to the data assigned.
Stop cyclical-send of 18x
Not displayed when the value of “100rel” is “disable”.
May be displayed “enabled”, pertaining to the data assigned.
Called-number pattern May be displayed “Request-URI”, pertaining to the data assigned.
isub function May be displayed “enabled”, pertaining to the data assigned.
184
→
0 Privacy function Displayed as pattern shown below, pertaining to the data assigned.
“disable”
“enable (1)”
“enable (2)”
Self SIP domain mode
May be displayed "enabled", pertaining to the data assigned.
Self SIP domain string
Not displayed when the value of “Self SIP domain mode” is “disable”.
Domain name assigned will be displayed when “enable”.
DTMF Mode Displayed as pattern shown below, pertaining to the data assigned.
“Negotiation (SIP/SDP)”
“In-Band (G.711)”
“Out-Band (RFC2833)”