NEC SV8500, Manual

Page: 262 / 3438

VOL.2-9
IP-BS (BS301)
-Use the broadcast by using ping command
(Example: In the case of “10.2.168.0/24”, enter “ping 10.2.168.255”)
[3] Default Gateway IP Address
Command: set dgw
Example: Default Gateway IP address is “10.41.207.254”
When IP-BS receives the settings successfully, set done message is displayed. This specified settings
can be displayed by using show dgw command.
[4] IP Address and Port Number of DRS
Note:
About IP address of DRS (Telephony Server), refer to “Registration Destination of IP Devices/Stations” in
INTRODUCTION of Installation Manual.
< IP Address of Primary DRS>
Command: set drspip
Example: Primary DRS IP Address is “10.41.207.30”
When IP-BS receives the settings successfully, set done message is displayed. This specified settings
can be displayed by using show drspip command.
< Port Number of DRS>
Command: set drsudp
Example: DRS Port Number is “3457”
When IP-BS receives the settings successfully, set done message is displayed. This specified settings
can be displayed by using show drsudp command.
Specify a port number if it is different from the default port (3456).
>set dgw 10.41.207.254
set done
>set drspip 10.41.207.30
set done
>set drsudp 3457
set done