NEC SV8500, Manual

Page: 1352 / 3438

VOL.2-1099
MG(PRI) (1.5M) [SCA-24PRIA/MG-24PRIA]
19. SET
Δ
PAD0
Δ
[ P1 ]
This command is used to specify PAD 0 data for PRI (1.5M). To make this assignment effective, it is re-
quired to execute the “SAVE” command and to restart before exiting the maintenance command.
When P1 is not entered:
When P1=0000:
The sending (snd) and receiving (rcv) values vary depending on PAD settings of ARTD (PBX settings) and PAD
Pattern Number. The following are divided into two sheets in the case of the
A-Law/
μ
-Law
settings, which de-
scribe the snd/rcv values:
MG-PRI(SIP)>SET PAD0
A-law/
μ
-law Setting (0-4: 0):0
1) Select a type of CODEC
0 =MGC Control (PBX System Data) (default)
1 =
μ
- law
2 =A - law
3 =Convert from A - law to
μ
- law
4 =Convert from
μ
- law to A - law
PAD Selection (0/1: 0):0
2) Select a type of PAD selection
0 =Standard (default)
1 =Flexible
PAD Control (0-3: 0):0
3) Select a type of PAD Control
0 =Receiving Control (MG
→
ISDN Network) (de-
fault)
1 =Sending Control (ISDN Network
→
MG)
2 =Fixed to ARTD
3 =Sending/Receiving Control
PAD Pattern No. (0-4: 0):0
4) Select the number of PAD Pattern
0-4 =Pattern Number (default value: 0)
* For more detailed information about the PAD patterns,
see the tables below.
Data PAD Pattern No. (0-4: 0):0
5) Select the number of Data PAD Pattern
0 =64K(default)
1 - 4 =Not available
set value is 0x0000
setting succeeded.
Result is displayed.
MG-PRI(SIP)>SET PAD0 0000
P1 -Specifying a set value
0000-FFFF = Set value (default value: 0000)
set value is 0x0000
setting succeeded.
Result is displayed.