NEC SV8500, Manual

Page: 1730 / 3438

VOL.2-1477
MG-SIP128 [MG-128SIPMGJ]
18.3.5 Setting of Pilot Number for MG-SIP128 [MG-128SIPMGJ]
Assign a pilot number of MG-SIP128 [MG-128SIPMGJ].
[Display example]
Note:
• Pressing the Enter key can skip the item.
• To make this assignment effective, it is required to execute the “REBOOT” command to save the configura-
tion and restart the MG-SIP128 [MG-128SIPMGJ].
Rebooting of MG-SIP128 [MG-128SIPMGJ]
Reboot the MG-SIP128 [MG-128SIPMGJ] by using “reboot” command. The assigned configuration data can
also be saved onto the Flash memory by using this command.
Note 12: Before selecting “Y” to save the running configuration data to the Flash memory, be sure to execute
the following commands:
•set ipaddress (Assign the IP addresses for LAN network side and SIP network side)
•set drsaddress (Assign the IP address of the Telephony Server)
•set sip_server (Assign the IP address of the SIP proxy server) *
•set keynumber (Assign a pilot number.)
MG(SIP)> set keynumber
Input Keynumber.(default=0, MAX32(strings))
:0 Assign the pilot number used by MG-
SIP128 [MG-128SIPMGJ].
(Default: 0).
MG(SIP)> reboot
Do you want to save Config data? Y/N=y
Select if you want to save the configuration data.
y: save the configuration data. Note 12
n: do not save the configuration data.
If other than the above is selected, the following
message is displayed.
“Reboot” command was interrupted.
Do you want to reboot MG(SIP)? Y/N=y
Select if you want to reboot MG-SIP128 [MG-
128SIPMGJ].
y: reboot MG-SIP128 [MG-128SIPMGJ].
n: do not reboot MG-SIP128 [MG-128SIPMGJ].
If other than the above is selected, the following
message is displayed.
“Reboot” command was interrupted.
Config data File write start.
Config data File write end.
MG(SIP)reboot start...