NEC SV8500, Manual

Page: 1562 / 3438

VOL.2-1309
MG-T1(SIP) [SCA-24DTIA]
SETUP COMMAND
Assign IP network data and T1 interface data following the setting command shown in dialog form. Be sure to
save the entered data at the end of each SETUP command.
Note:
When any abnormal data is entered, the dialog asks to enter proper data until three times. In the third time
you enter illegal data, the SETUP command quits discarding all the entered data.
Note:
When you quit the SETUP command entry halfway through the setting, all the entered data is to be discard-
ed.
1. SETUP
Δ
SP
This command is used to set up a series of IP network data such as IP address, subnet mask, and DHCP for
MG-T1(SIP).
F
To startup SETUP SP command:
F
Setting DHCP server enable/disable:
F
Setting DNS server enable/disable:
MG-T1(SIP)>
MG-T1(SIP)> SETUP SP
Enter “SETUP SP” following the prompt.
--- DHCP Interface set ---
Current DHCP Interface: ENABLE
The current setting is displayed.
Change DHCP Interface? [Y(change)/N(current)/Q(quit)]: y
Asked whether to change the displayed set-
ting.
Y: Change the setting
N: Remain the current setting
Q: Exit this setting
Input new DHCP Interface [E(enable)/D(disable)]: d
Specify whether to use DHCP server.
E: Use DHCP server (default)
D: Not use DHCP server
--- DNS Interface set ---
Current DNS Interface: DISABLE
The current setting is displayed.
Change DNS Interface? [Y(change)/N(current)/Q(quit)]: y
Asked whether to change the displayed set-
ting.
Y: Change the setting
N: Remain the current setting
Q: Exit this setting
Input new DNS Interface [E(enable)/D(disable)]: e
Specify whether to use DNS server.
E: Use DNS server (default)
D: Not use DNS server
(*Go on to DNS IP address setting when
“E” is selected.)