NEC SV8500, Manual

Page: 1410 / 3438

VOL.2-1157
MG(PRI) (2M) [SCA-30PRIA/MG-30PRIA]
Assign the Trunk Data to Virtual Signaling Channel, referring to page 1155.
STEP 10:MBTK (Make Busy of Trunk)
Cancel the Make-Busy of Virtual Speech Path.
RT: Route Number
TK: Trunk Number
MB: 0=Make-Busy Cancel
STEP 11:AMGIL (Assignment of Media Gateway Information for LDM)
Note:
Make sure to assign in order of ATRK → AMGIL.
Assign MG(PRI).
MG-ID: MAC Address of MG(PRI) (6 byte of HEX data)
* MAC address is labeled on the left front of MG(PRI) (below PWR lamp).
FUNCTION:Setting (to assign MG information)
KIND:
ISDN Trunk (PRI 2M)
LINE: 0 (fixed)
CH: 0 (fixed)
LENS: Accommodating Location of Virtual Speech Channel.
Assign the first channel of HW to which Virtual Speech/Signal Channel is allocated.
*
Make sure that LENS number assigned here already has been assigned by the ATRK.
RETRY: Number of retry to request connection to MG(PRI).
SERVICE TYPE:QoS settings of signal path (ToS value applied when Internal PHI-PRI connects to
MG(PRI))
STEP 12:AMGVL (Assignment of Media Gateway Voice Control Data for LDM)
Assign the Voice control data to connect to MG(PRI).
A RT (Storing MG):Route number of virtual speech channel used for MG(PRI).
TYPE:
Select “Route Specified” or “Location ID Specified”.
B RT (MG Storing): Displayed when TYPE=Route Specified is selected.
Used when connecting MG and MG in Tandem. Assign the route number of virtual
speech channel for the destination MG.
B LOC-ID: Displayed when TYPE=Location ID Specified is selected.
Assign the location ID where the destination IP station belongs. (Preferred)
Setting of Jitter Buffer:JB_MIN [0-30 ( × 10 milliseconds)], JB_MAX [0-30 ( × 10 milliseconds)]
Setting Type of Voice Packet Service: IP PRECEDENCE [0-7]/DIFFSERV [00-63]
Setting of Payload:TYPE, SIZE
Note 1
Note 1:
For using this parameter, refer to Peripheral Equipment Description, Volume 1, Chapter 2, “3.1.1 Band-
width Required for Voice Traffic.”
RESET THE MG(PRI) BY PUSHING RESET BUTTON AFTER ASSIGNING DATA.