NEC SV8500, Manual

Page: 2286 / 3438

VOL.2-2033
VS-32(Dual) [SCA-VS32VA/MG-VS32VA]
24.4 Operation and Maintenance
24.4.1 How To Use Maintenance Command
Maintenance Command is used to change the VS-32(Dual) configuration setting. Default value is pre-assigned
for the basic items. Therefore, execute the data change only when needed.
SETUP command is provided to assign the basic data collectively. At least IP address and music source file set-
ting are required to start up VS-32(Dual). Use SETUP TP for Proprietary Protocol mode, SETUP SP for SIP
mode, and SETUP WAVEFILE for music source file setting respectively.
Use SET command to assign other data into details. Specify any required parameter for each item. For example,
DHCP setting has “ENABLE” in default. When static addressing is required, assign the commands “DHCP”,
“IPADDRESS”, and “DEFAULTROUTE”.
Note:
“SIP server” used in this section refers to the Telephony Server. When VS-32(Dual) works in SIP mode,
Telephony Server acts as SIP server.
Note:
“DRS (Device Registration Server)” used in this section refers to the Telephony Server. When VS-32(Dual)
works in Proprietary Protocol mode, the Telephony Server acts as DRS, which is controlling function of the
Telephony Server.
Run terminal software (e.g. HyperTerminal) to start maintenance program. Maintenance command launches by
entering “usrConsole” following the OS prompt (
Note 1
). When the system is ready, the following prompt is
shown on the screen. (*VS-32(Dual) starts up in Proprietary Protocol mode in default setting.)
<Proprietary Protocol mode>
VS-32>_
<SIP mode>
VS-32(SIP)>_
Note 1: •
When “exit” is entered on OS prompt, setting screen may stop. In this case, press CTRL + C keys to
return to prompt.
•
Key operation of CTRL + C keys on maintenance console may stop setting screen. In this case, press
CTRL + Q keys to return to prompt.
Maintenance Command consists of some components: Command, Sub-command, and Parameter. The values to
be assigned for each Parameter depend on the Maintenance Command, some of the Maintenance Commands do
not require any parameter. A space needs to be entered between Command, Sub-command, and Parameter.
An example screen setting IP address (10.10.15.5) and subnet mask (255.255.255.0) in the system data of VS-
32(Dual) is shown below: