NEC SV8500, Manual

Page: 789 / 3438

VOL.2-536
MG-COT Card [SCA-6COTA/SCA-6COTC]
ALOCL: Assignment of Location ID Data (LDM)
Each IP terminal is allocated a Location ID to identify its location within the network on Network Address
basis. By using the Location ID, IP services such as Bandwidth Control and ToS Control are provided for
each IP terminal.
TYPE: Select “Network Address”.
IP ADDRESS: Enter the IP Address. For the Telephony Server (IPPAD), assign “0.0.0.0”.
MASK BIT: Enter the Mask Bit in the range of 1-31 except when IP Address 0.0.0.0 is determined. Mask
Bit=32 is automatically set when IP Address=0.0.0.0
NETWORK ADDRESS: Display only.
LOC-ID:
Assign the Location ID in the range of 0-4095, associated with the IP Address. When IP Ad-
dress=0.0.0.0, LOC-ID=0 is automatically set (the value cannot be changed).
Note:
LOC-ID=0 is predetermined to the Location ID of the Telephony Server (i.e.IPPAD).
Setting Type of Signaling Packet Service: Click the check box to assign the ToS for signaling packet.
IP PRECEDENCE/DIFFSERV:
<When IP PRECEDENCE is selected>
Priority: Specify the precedence in the range of 0-7 (low-high).
Low Delay: Place a checkmark to set Low Delay to ON.
Through Put: Place a checkmark to set High Throughput to ON.
Reliability: Place a checkmark to set High Reliability to ON.
MIN Cost: Place a checkmark to set Cost Precedence to ON.
<When DIFFSERV is selected>
Priority: Specify the DiffServ Code Point in the range of 0-63.
Note:
Default settings (IP PRECEDENCE, Priority=6, Low Delay=OFF, Throughput=OFF, Reliability=OFF,
Min Cost=OFF) is applied when the check box is not clicked.
AIVCL: Assignment of IP Service Voice Control Data (LDM)
A LOC-ID:Location ID of the self-location [0-4095]
B LOC-ID:Location ID of the destination location [0-4095]
Setting of Jitter Buffer: Click the check box to assign the Jitter Buffer data.
JB_MIN: Jitter Buffer minimum value [0-30 (
×
10 milliseconds)]
JB_MAX: Jitter Buffer maximum value [0-30 (
×
10 milliseconds)]
Note:
Default settings (JB_MIN=1 (10 ms), JB_MAX=30 (300 ms)) is applied when the check box is not clicked.
Setting of Type of Service (Voice Packet): Click the check box to assign the ToS data for voice packet.
IP Precedence/DiffServ: Select either of the radio buttons.
<When IP Precedence is selected>
Precedence: Specify the precedence in the range of 0-7 (low-high).
Low Delay: Place a checkmark to set Low Delay to ON.
Through Put: Place a checkmark to set High Throughput to ON.
Reliability: Place a checkmark to set High Reliability to ON.
MIN Cost: Place a checkmark to set Cost Precedence to ON.
<When DiffServ is selected>
DSCP: Specify the DiffServ Code Point in the range of 0-63.